Parts Identification
4
No. Item
Description
1 Power LED
Indicates that the adaptor is being supplied
with power.
2 Status LED
Indicates the status of the adaptor.
Blue: Wireless mode
Green: Ethernet mode
Red: Abnormality
White: Timer
3 Link LED
Indicates the communication status of the
adaptor.
4 WPS switch
Switches WPS ON.
5 Register/Reset switch
Enables user registration and resetting.
6 Check switch
Check the communication status of the
adaptor.
Switches between Ethernet and Wireless
modes each time it is pressed and held for
10 seconds.
1
2
3
5
6
Connecting Network
You can establish a connection with the internet with either the Ethernet
mode (wired) or the Wireless mode (wireless).
1 Turn on the power supply to the indoor unit.
∙ The Power LED lights.
2 The colour of the Status LED indicates the connection mode�
Power LED
Status LED
The colour of the Status LED changes each time the Check
switch is pressed and held for 10 seconds.
■
When connecting using the Ethernet mode (wired)
1 Check the Status LED is green to confirm that the
Ethernet mode is on�
∙ If the Ethernet mode is not on, press and hold the Check switch for
10 seconds to switch to the Ethernet mode.
2 Connect the router and the adaptor with a LAN cable.
∙ The Link LED lights to indicate that the connection has been established.
∙ Use a shielded LAN cable.
■
When connecting using the Wireless mode (wireless)
1 Check the Status LED is blue to
confirm that the Wireless mode is
on�
∙ If the Wireless mode is not on, press and
hold the Check switch for 10 seconds to
switch to the Wireless mode.
2 Switch on WPS on the router.
3 Press the WPS switch on the adaptor.
∙ The Status LED and Link LED light when communication is established.
* Refer to Troubleshooting (P.7), "When you cannot connect in the
Wireless mode" or "When you cannot connect in the Ethernet mode" when
you cannot connect to the network.
4
Status LED: Green (Ethernet mode)
Status LED: Blue (Wireless mode)
WPS switch