Livestrong LS10.0T Manuel Du Propriétaire page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY STEp 1
HARdWARE bAG 1 CONTENTS :
BOLT (A)
20 mm
Qty: 6
CONSOLE MAST
MAIN
FRAME
BOOT
BOLTS (A)
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
10
SPRING WASHER (B)
ARC WASHER (C)
8.2 mm
8.2 mm
Qty: 6
Qty: 6
LEAD WIRE
CONSOLE CABLE
A
Cut the yellow banding straps and lift the running
deck upward to remove all contents from underneath
the running deck.
Open hardware bag 1.
B
C
Slide main frame boot up console mast.
Place right console mast over main frame
bracket.
D
Pull lead wire through right console mast.
After pulling the lead wire through the mast, the
top of the console cable should be located at
the top of the mast. Detach and discard lead wire.
NOTE: Do not pinch console cable when
placing the mast onto the main frame bracket.
E
Attach console mast to main frame
bracket using 3 bolts (a), 3 spring
washers (b) and 3 arc washers (c).
NOTE: Do not tighten bolts until step 3 is complete.
Slide main frame boot down over main frame
F
bracket.
g
Repeat steps D–F on other side.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ls13.0t

Table des Matières