Connecting The Power/Leveling The Unit - Whirlpool W11518243A Manuel D'utilisation

8. Bend the copper tubing to meet the water line inlet, located
on the back of the refrigerator cabinet as shown. Leave a coil
of copper tubing to allow the refrigerator to be pulled out of
the cabinet or away from the wall for service.
Connect to Refrigerator
Follow the connection instructions specific to your model.
1. Remove plastic cap from water valve inlet port. Attach the
copper tubing to the valve inlet using a compression nut
and sleeve as shown. Tighten the compression nut. Do not
overtighten. Confirm copper tubing is secure by pulling on
copper tubing.
2. Create a service loop with the copper tubing. Avoid kinks
when coiling the copper tubing. Secure copper tubing to the
rear panel with a "P" clamp, using the original screw in the
panel slot above the valve.
A
B
C
D
A. Copper tubing
B. "P" clamp
3. Turn on water supply to refrigerator and check for leaks.
Correct any leaks.
C. Compression nut
D. Compression sleeve
Connecting the power/
Leveling the unit
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Plug the power cord into its AC outlet, and push the
refrigerator back against the wall.
2. Place a level on top of the refrigerator cabinet. If you need
to relevel, follow the procedure outlined in your refrigerator's
User Guide.
11