AEG S 17 TK 58 Mode D'emploi page 29

Dismount the door holder at the
bottom on the right side. For this,
drive the three screws out, and
pull the door holder down
together with the door holder
pin. Remove the screw on the left
side, and drive it in on the right
side.
Remove the door by pulling it
downwards while keeping it
slightly opened.
Unscrew the upper door holder, and screw it in on the opposite side.
Put the door back in its place.
Relocate the door holder pin in the
door holder as per the figure.
Place the door holder pin in the
door at the bottom on the left
side, and fix the door holder with
the screw.
Drive in the two adjustable front
legs, and raise the appliance in the
upright position.
Relocate the door handle from the
left side to the right, and blind the bore-holes with the plugs delivered with
the appliance.
To reverse the handle proceed as follows:
Remove screw covers (if fitted) and
handle retaining screws. Remove
blanking plugs on the opposite
side using a punch.
Relocate the handle to the
opposite side and refit retaining
screws (covers if fitted), and push
the plastic plugs supplied with
the appliance into the holes
where the handle was previously
fitted.
29