en
Disposal
Disposal
J
Dispose of packaging in an environ
mentallyfriendly manner. This
appliance is labelled in accordance
with European Directive 2012/19/EU
concerning used electrical and
electronic appliances (waste electrical
and electronic equipment – WEEE).
The guideline determines the frame
work for the return and recycling
of used appliances as applicable
throughout the EU. Please ask your
specialist retailer about current
disposal facilities.
Simple troubleshooting
Problem
Strongly fluctuating coffee
or milk froth quality (e.g.
fluctuation in quantity or
milk froth spraying).
Milk froth quality varies
widely
Drinks cannot be
dispensed.
The drink runs out at
the entire outlet during
dispensing.
Too little milk froth, none
at all, or the milk system
is not taking in any milk.
48
Cause
Buildup of limescale in the
appliance.
The suction pipe is blocked.
The quality of the milk froth
depends on the type of milk
or the plantbased alternative
used.
Beverage outlet or one of the
3 connections are blocked.
Lower part of the beverage
outlet is missing.
Buildup of limescale in the
appliance.
Beverage outlet or one of the
3 connections are blocked.
Milk not suitable for foaming.
Beverage outlet or the milk
tubes are not correctly
assembled.
The suction pipe is blocked.
Guarantee
The guarantee conditions for this appliance
are as defi ned by our representative in the
country in which it is sold. Details regarding
these conditions can be obtained from
the dealer from whom the appliance was
purchased. The bill of sale or receipt must
be produced when making any claim under
the terms of this guarantee.
Changes reserved.
Solution
Descale the appliance accord
ing to the instructions, see the
section "Service programmes".
Clean the suction pipe.
Optimise the result through the
selection of the type of milk or
plantbased drink.
Clean the beverage outlet and
the connections.
Attach the lower part, see the
section "Cleaning the milk
system".
Descale the appliance accord
ing to the instructions, see the
section "Service programmes".
Clean the beverage outlet and
the connections.
Do not use milk that has
already been boiled. Use cold
milk with a fat content of at
least 1.5%.
Moisten the individual parts and
put them together again.
Clean the suction pipe.