Care And Daily Cleaning - Bosch CTL636E.1 Mode D'emploi

■ Then empty the container.
The appliance is ready for use again.
F
Rinsing the filter simultaneously
activates the setting for the change
filter display.
The filter is no longer effective when the
"Replace water filter – Press A" display
appears, or at the latest after two months. It
needs to be replaced for reasons of hygiene
and to prevent a build­up of limescale
(which could damage the appliance).
■ If a new filter is not inserted, select the
setting [ remove ] and press C.
The message "Remove filter, reinsert
water tank, close door" appears.
F
If the appliance has not been used
for a prolonged period (for example,
while you are on holiday), the exist­
ing filter should be rinsed before the
first time the appliance is used again.
To do this, simply dispense a cup of
hot water.
Detailed information about the water filter
can be found in the manual supplied with
the filter.
Switch off after
To set how long the appliance should wait
after the last drink was prepared before it
automatically rinses and switches itself off.
You can specify values from 15 minutes to
8 hours. The factory setting is 30 minutes.
Illumination
Setting the illumination of the beverage
outlet. "on", "when in use" or "off" can be
selected.
Brightness illumination
Setting the illumination lightness of the
beverage outlet. "Level 1" to "Level 10" can
be selected.
Brightness display
Setting the illumination lightness of display.
Key tones
Switch the signal tones on or off.

Care and daily cleaning

Clock displ.
Display option for time Off or Digital (on).
The setting for this can be changed in the
Clock menu option.
F
If the appliance is switched off at
the mains or there is a power failure,
the settings for the time will be lost.
Clock
Setting for the current time.
Frost protection
Service programme to prevent frost damage
during transportation and storage.
This programme completely empties the
appliance.
■ Empty the water tank and reinsert.
■ If available remove the milk container and
close the door.
The appliance automatically empties all its
pipes.
■ Empty the drip tray and re­insert.
Beverage info
Display shows how many drinks have been
prepared since its initial use.
Factory settings
Resets your own settings to the condition
when delivered.
■ Touch [ Reset ] or [ D o not reset ] to either
confirm or interrupt.
Care and daily cleaning
E
Risk of electric shock!
Never immerse the appliance in
water. Do not steam­clean the
appliance.
■ Wipe the outside of the appliance with a
soft, damp cloth.
■ Clean the control panel using a micro­
fibre cloth.
■ Do not use any cleaning agents contain­
ing alcohol or spirits.
en
41