Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
ASSEMBLY INSTRUCTIONS
Step 1
Attach the rear stabilizer (3) to the main
frame (1) using two sets of domed nuts (6),
washers (5) and key head bolts (4).
Attach the front stabilizer (2) to the main
frame (1) using two seats of domed nuts (6),
washers (5) and key head bolts (4).
Step 2
Take the front post (15) and connect the
upper sensor wire and lower sensor wire.
Then slide the front post (15) into the front
post housing, then fix with Allen key bolts
(11) and four washers (5).
Twist the resistance knob to minimum
before hanging the resistance line.
Step 3
Fix the seat (12) to the seat post (9) using
three small washers (11) and three nylock
nuts (10) located under the seat.
23
Publicité
Table des Matières
