Teamtex ENO 360 Mode D'emploi page 28

EN
Group 2 / 3
(For children who weigh 15-36 kg)
•
First, remove the belt system as described
1
in the previous section "Removal of the belt
system"
•
Place the child car seat onto the car seat
2
and move it into the forward-facing position.
•
Press the two lateral Isofix connector
buttons in order to extend the Isofix connec-
tors to their full length.
•
Insert the Isofix connectors into the insertion
aids and press until they lock.
•
The display on both sides only turns green
when the connections have been estab-
lished. Pull the child car seat to the back rest
until it is standing securely.
•
Installation in group 2/3 may also be car-
ried out without Isofix connectors.
•
Put the child in the child car seat.
3
•
Adjust the height of the head support so
that the red belt guide remains free under
the head support.
•
Insert the safety belt of the car through the
red belt guide under the head support of the
child car seat.
•
Ensure that the pelvic restraint goes through
the side of the child car seat.
•
Please make sure that in particular the pel-
vic restraint is close fitting and is as low as
possible over the pelvis of the child.
•
Close the 3-point safety belt with the buckle
on the car seat. Make sure that the 3-point
safety belt is not twisted.
•
Pull the 3-point safety belt of the vehicle
as tight as possible and check whether the
child car seat is standing securely.
28
- 28 -
CLE
This pr
take th
safe p
In orde
or agg
wash.
compl
30
30
30
MAI
Regula
use th
If you h