PLS NEW PLS5 Manuel D'utilisation page 16

Pendulum Target
Use the PLS 5 pendulum target for a variety of time saving alignment tasks. For square: For con-
sistent accuracy in establishing or checking square, use the PLS 5 target to transfer the laser
beam to the floor surface. To establish square, see page 8 of this manual. Always mount the
5
PLS laser on the floor stand when establishing square. The pendulum target is designed so the
beams are best seen at this height.
For transfer of vertical lines:
To transfer vertical marks quickly and accurately to a wall:
1. Place the front of the PLS
5 laser against the wall with the #1
forward beam on the mark to be transferred. (If the mark is on the
floor, place the #2 down beam over the mark.)
2. Place the target with its back flat against the wall at the desired
height and move the target until the #3 up beam is centered on
the plastic lined target.
3. Mark the top or bottom of the target arrow pins.
PENDULUM TARGET
FIG. 13
13