Shift Function; Programming Macros - Medion MD 81035 Mode D'emploi

SHIFT function

Some of the keys of the universal remote control can have
two assigned functions. To use these functions, briefly
press the SETUP key (the source key will light up) and then
press one of the function or number keys.
If no other key is pressed for 15—20 seconds after the
SETUP key was briefly pressed, the SHIFT function will not
become active.
Deleting functions
Deleting commands for only one source key
1. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
2. Briefly press the desired source key (TV, VCR, DVD,
ASAT, DSAT, CBL, CD, AUX).
3. Press the LEARN key twice.
4. Press the SETUP key.
All commands of the relevant source key have now been de
leted.
Deleting commands for all source keys
To delete all commands altogether, proceed as follows:
1. Keep the SETUP key pressed down for approx. 3
seconds, the background lighting of the source key will
flash for a short time and then remain permanently lit.
2. Press the LEARN key twice.
3. Press the SETUP key.
All codes that were programmed using the learn function
have now been deleted.

Programming macros

Using a macro, you can save a chain of commands, meaning
that several functions can be executed consecutively. You
can program three macros and store them on the number
keys 1, 2 and 3.
Each macro can include up to ten key commands. A macro
can include different devices. In this way you could, for ex
ample, switch on the TV set, the desired channel, the video
recorder and the recording function.
1. Switch the device(s) on.
2. Keep the SETUP key pressed down for approx. 3
seconds until the background lighting of the source key
flashes briefly and then remains permanently lit.
3. Press the MACRO key. The source key will flash briefly.
4. Press the number under which the macro should be
stored, i.e. "1", "2", or "3".
5. Press a source key (device selection, e.g. VCR) for the
device with which you would like to start (first key com
mand).
6. Now carry out the functions that you would like to save
as a macro in the desired sequence. You may now carry
out nine key commands. The source key will extinguish
briefly each time the button is pressed.
7. To save the macro, press MACRO (the macro will be
saved automatically after the 10th key has been pres
sed). The source key will extinguish permanently.
9
UK