Front Panel - Ramiaudio FDI1000 Manuel Utilisateur

FRONT PANEL

1
1 - Programming and display of cell 1.
2 - Programming and display of cell 2
3 - Programming and display of cell 3
4 - Programming and display of cell 4
5 - Programming and display of cell 5
6 - Programming and display of cell 6
7 - Programming and display of cell 7
8 - Programming and display of cell 8
9 - Programming and display of cell 9
10 - Programming and display of cell 10
A - Manual cell commutation test switch
B - Programming dip switch :
1 - Switch allowing coupling to preceding cell and multiple commutations from one single
information on the input. The switch is active in low position.
Note : If several cells are coupled, the remote control information can be linked to any of
the coupled cells inputs.
Moreover, if you link two or more inputs to different remote control signals, the coupled
cells will work with a OR logical function
2 - Cell isolation switch from the input remote control. This allows, associated with switch A, a
test of a part of the audio chain, e.g. if the start /stop of a machine works OK. The cell is
isolated when the switch is in up position.
3 - Programming switch (pulse or hold mode for the Start relay).
Pulse mode in upper position of the switch. (An incoming permanent information on
the input will cause a 100 ms closure of the Common and Work contacts of the Start relay).
Hold mode in lower position of the switch. (An incoming permanent information on the
input will cause a permanent closure of the Common and Work contacts of the Start
relay with a duration identical to the input information).
Rami
2 3 4 5 6 7
14
8 9 10
FDI1000