Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Follow these instructions to install the pedestal on a washer or
dryer.
WARNING
Excessive Weight Hazard
Use two or more people to move and install pedestal.
Failure to do so can result in back or other injury.
1. Locate the levers on the drawer slides on each side of the
drawer.
A
A. Drawer slide
B. Lever
2. Pull the lever up on the left side of the drawer and at the same
time, push the lever down on the right side. While holding the
levers in position, pull the drawer all the way out and set aside.
Push the slides back into the pedestal.
A
A. Lever (right side shown)
3. If your washer or dryer has feet installed, remove them. Do not
install the feet that came with a new washer or dryer.
4. Set the pedestal in its final location.
4
INSTALLATION INSTRUCTIONS
Install Pedestal
B
5. Level the pedestal from side to side and front to back.
NOTE: Make sure all 4 pedestal feet are in solid contact with
the floor.
Place a level on the top of the pedestal. Locate the ¼" hex
head screws on the top of each pedestal foot. Reach inside
the pedestal and use a ratchet with a ¼" socket or open-
ended wrench to adjust the feet up or down as needed to level
the pedestal.
6. Once the pedestal is level, use a ⁹⁄₁₆" (14 mm) open-ended
wrench to tighten all 4 locknuts against the pedestal. The
locknuts must be tightened to avoid vibration.
A
A. Locknuts
B. Pedestal cabinet
7. Use a ratchet with a ⁹⁄₁₆" (14 mm) socket or open-ended
wrench to partially install the 4 attachment bolts in the proper
holes. Leave a space of about ³⁄₈" (1 cm) between the bolt
head and the bottom of the washer or dryer.
A. Washer/Dryer bottom
B. Attachment bolts
B
A
B
Publicité
Table des Matières
