Continuous Pilot / Intermittent Pilot (Cpi / Ipi) Selection; Key Lock; Low Battery; Battery Holder/Backup Installation - Napoleon GDS26N-1 Instructions D'installation Et D'opération

8.7

CONTINUOUS PILOT / INTERMITTENT PILOT (CPI / IPI) SELECTION

A. Use the Mode Key to guide you to the CPI mode icon.
Transmitter in the OFF position.
B. Press the UP/DOWN to switch between IPI and CPI
modes. A single BEEP will confi rm reception of the
command.
NOTE: If the system is equipped with a CPI/IPI toggle
switch, set the CPI/IPI to CPI position to enable remote CPI
operation. If the switch is set to IPI then it will only work in
IPI regardless of what is set on the remote control handset.
8.8

KEY LOCK

This function will lock the keys to avoid unsupervised operation.
A. Press the MODE and UP keys at the same time.
B. To de-activate this function, press the MODE and UP keys at the same
time.
8.9

LOW BATTERY

The life span of the remote batteries depends on various factors: quality of the batteries,
the number of ignitions, the number of charges to the room thermostat set point, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD display
before all battery power is lost. When the batteries are replaced this icon will disappear.
8.10

BATTERY HOLDER/BACKUP INSTALLATION

The battery holder is located in the valve
A.
compartment accessible for programming
the remote.
Install 4 AA batteries, ensure that the
B.
positive and negative ends correspond
with those identified in the battery holder.
In the case of a power outage the 3
C.
position slider switch needs to be in the
"ON" position (left).
NOTE: Ensure the 3 position slider
switch is in the "REMOTE" position
(middle).
76
°F
IPI CPI
35.22
35.10A
35.24
RESET/PROGRAM BUTTON (PRG)
39
EN
76
°F
76
°F
76
°F
W415-2183 / B / 02.10.17