handset one-Button operation
(Default Setting)
AM
PM
▪ Press
and a blinking series of lines confirms
ON
OFF
the start sequence has begun; release
1 2
button.
▪ Main gas flows once pilot ignition is
confirmed.
▪ Handset automatically goes into Man-
ual Mode after main burner ignition.
NOTICE
Change from one-button to two-button ignition operation by
pressing and holding
button for 10 sec. immediately after
installing batteries.
is displayed and
change is complete will change to .
handset Two-Button operation
▪ Press
AM
PM
until two short beeps and a blinking
series of lines confirms the start se-
ON
OFF
quence has begun; release buttons.
1 2
▪ Main gas flows once pilot ignition is
confirmed.
▪ Handset automatically goes into Man-
ual Mode after main burner ignition.
NOTICE
Change from two-button to one-button ignition operation by
pressing and holding
button for 10 sec. immediately after
installing batteries.
is displayed and
change is complete
will change to .
WARNING
If the pilot does not stay lit after several tries, turn the main valve
knob to oFF and follow the instructions "TURN OFF GAS TO
APPLIANCE" (page 30).
STaNDBy moDE (pILoT FLamE)
handset
▪ Press and hold
button to set appliance to pilot flame.
To TURN oFF FIRE
handset
▪ Press
AM
PM
NoTE:
ON
OFF
1 2
UK
button until two short beeps
is flashing. When
and
button simultaneously
is flashing. When
button to turn OFF.
There is a 5 sec delay before
the next ignition is possible.
FLamE hEIghT aDjUSTmENT
AM
PM
ON
OFF
1 2
DESIgNaTED LoW FIRE and hIgh FIRE
NoTE:
Backlight must be on for high fire and low fire double-click
operation.
AM
AM
WARNING
If the appliance will not operate, follow the instructions "TURN
OFF GAS TO APPLIANCE" (page 30).
coUNTDoWN TImER
AM
PM
ON
OFF
1 2
NoTE:
At end of countdown time period, the fire turns off. The
Countdown Timer only works in Manual, Thermostatic,
and Eco Modes. Maximum countdown time is 9 hours
and 50 minutes.
38
handset
▪ To increase flame height press and
hold
button.
▪ To decrease flame height or to set ap-
pliance to pilot flame, press and hold
button.
▪ To go to low fire, double-click
ton.
is displayed.
NoTE:
Flame goes to high fire first be-
fore going to low fire.
▪ To go to high fire, double-click
ton.
is displayed.
ON/SETTING:
1. Press and hold
button until
played, and hour flashes.
2. To select hour press
or
3. To confirm press
button. minutes
flash.
4. To select minutes press
or
5. To confirm press
button or wait.
OFF:
Press
button,
and countdown time
disappear.
but-
but-
dis-
button.
button.