Control Panel Operation - Quick WCD 1022 Manuel D'installation Et D'emploi

CONTROL PANEL OPERATION

Control panel
The user interface is composed of 1 enablement button, 1 enablement Led, 2 direction buttons, 2 direction Leds.
Enablement button
The button enables or disables the control.
Direction buttons
The UP direction button raises the anchor.
The DOWN direction button drops the anchor.
Enablement Led
The enablement Leds indicate
the enabled/disabled state of the control.
Direction Leds
The direction LEDs indicate the movement
of the anchor upwards and downwards.
All Leds are also used to signal any errors or problems.
REMOTE CONTROL ENABLING
To enable the remote control, press the enabling button and keep it pressed for at least 1 second.
After this period the enablement Leds will start flashing with greater frequency and the control will emit a short sound.
Release the enablement button, the enablement Leds will remain steadily lit on and the remote control will be enabled. In
this condition the control will emit a short sound every 5 seconds.
PRESS THE UP BUTTON
ANCHOR LIFT
When the windlass is activated the direction Led corresponding to the imparted movement (red to the left, green to the
right) will light on and the control will emit an intermittent sound.
NOTE:
The command introduces a 2-second delay in the event that the windlass is operated in one direction and an attempt is
made to operate it in the opposite direction (immediate change from UP to DOWN, or vice versa).
WCD 1022 REV001A
UP DIRECTION BUTTON
ENABLEMENT
LED
ENABLEMENT
BUTTON
DOWN DIRECTION BUTTON
PRESS THE DOWN BUTTON
ANCHOR DROP
OPERATION
EN
UP
DIRECTION LED
DOWN
DIRECTION LED
13