Quick WCD 1022 Manuel D'installation Et D'emploi page 10

CHARACTERISTICS AND INSTALLATION
EN
WCD REMOTE CONTROL
The WCD 1022 remote control has been designed to control the windlasses manufactured by Quick
The WCD 1022 remote control offers the following advantages:
• Simple and intuitive user interface.
• Universal power supply (from 8 to 31 Vdc).
• Can work in a wide range of ambient temperatures.
• Possibility of connecting several WCD commands in parallel.
• Easy to install by means of 2-wire connector (optional extensions).
• Automatic priority system.
• Automatic disablement.
• Protection against reverse polarity, short circuit output and interruption of windlass controls wiring.
• Acoustic signals (that can be deactivated).
INSTALLATION
The installation of the WCD remote control must be carried out by qualified personnel.
BEFORE USING THE WCD REMOTE CONTROL, READ THIS INSTRUCTION MANUAL CAREFULLY.
IN CASE OF DOUBTS, CONTACT QUICK
F
In case of discordance or errors in translation between the translated version and the original text in the Italian
language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
The WCD remote control has been designed and constructed for the purposes described in this instruction manual.
Quick shall not be held responsible for any direct or indirect property damage or personal injury caused by inappropriate
®
or unintended use of the equipment, incorrect installation or any errors that may be present in this manual.
THE WARRANTY SHALL BE VOID IF THE CONTROL IS TAMPERED WITH OR ALTERED BY NON AUTHORISED
PERSONNEL.
THE PACKAGE CONTAINS: WCD 1022 remote control - frame - drilling template - conditions of warranty - manual of
installation and use.
INSTALLATION OF REMOTE CONTROL
The typical installation procedure is described herein. Needless to say, it is not possible to describe a procedure applicable
for all situations that may be encountered. Adapt this procedure to satisfy your own personal requirements.
Locate the most suitable position to house the instrument following the recommendations given below:
• The remote control must be positioned so that it can easily be reached by the operator.
• Select a clean, smooth and flat area.
• Access from the rear must be available for installation and maintenance purposes.
• There must be enough space behind the chosen position in order to accommodate the rear of the control and the wires.
• The rear part of the remote control must be protected from water and damp.
• Pay careful attention when drilling the panel or parts of the boat. This hole should not weaken or break/crack the boat's
structure.
10
CUSTOMER SERVICE OR YOUR LOCAL DEALER.
®
.
®
.
®
WCD 1022 REV001A