Electric Connections - Quick WCD 1022 Manuel D'installation Et D'emploi

INSTALLATION
EN

ELECTRIC CONNECTIONS

The remote control complies with EMC standards (electromagnetic compatibility) but requires correct installation to avoid
compromising its performance and that of the surronding instruments.
For this reason the remote control wires must be positioned at a distance of at least:
• 1 m away from cables that transmit radio signals (except for SSB radio transmitters).
• 2 m away from cables for SSB radio transmitter signals.
Follow the rules below to construct the electrical installation relative to the remote control:
• Connect the remote control connector to the connector coming from the windlass.
• Put in a switch to turn on and shut off the instrument (not supplied).
• Position the switch so that it is within easy reach should it be necessary to shut off the instrument in an emergency.
• Insert a 4A quick-acting fuse on the control power supply line (not supplied).
• Use wires, for the control power supply, with a correct cross section according to their length.
• Do not use voltage from the motor or thruster battery circuit for the control.
• Before switching on the power to the control, check that all the electrical connections are correct.
ELECTRICAL CONNECTIONS DIAGRAM
MOTOR
*
BATTERY
*
Common negative for the battery groups.
12
HYDRAULIC-MAGNETIC
CIRCUIT BREAKER
FUSE
TO THE SERVICE
BATTERY
REVERSING
CONTACTOR
UNIT
COMMAND WIRE
(OPTIONAL)
WCD 1022
WINDLASS CONTROL
RED
BLACK
BLUE GREY
*
SPLITTER
(OPTIONAL)
WCD 1022 REV001A