Cleaning Tips; Quick Start - RugDoctor 93140 Serie Mode D'emploi

CLEANING TIPS

1. Before you begin, review the safety warnings found in the front of
this manual.
2. Always test color fastness before using on carpets and upholstery.
a. Wet an inconspicuous area with a small amount of cleaner
b. After 1-2 minutes, blot with a paper towel and check for
color transfer.
3. Using a normal dry vacuum cleaner, vacuum the area you want to
deep clean to remove loose dirt before using the Rug Doctor Deep
Carpet Cleaner machine.
4. Pre-treat any special problem areas with appropriate Rug Doctor
cleaning solutions (reference cleaning products on manual Page 5
and www.rugdoctor.com).

QUICK START

1. Raise the HANDLE by pulling the handle upward. Lift the handle into
the upright position. (Fig. 1)
2. Remove the CLEAN WATER TANK by grasping the TANK HANDLE
and lifting straight up. (Fig. 2). Loosen the TANK LID by turning
counter clockwise and remove from the machine, set
aside. Fill the tank with hot tap water to the "CLEAN
WATER FILL LINE". DO NOT USE BOILED OR MICROWAVED
WATER IN TANK.
3. The TANK LID is also the "Soap" measure. (Fig. 3) Fill the lid
with Rug Doctor cleaning solution to the desired level (measured
in ounces). Follow instructions on the cleaning solution bottle for
best results. Pour the cleaning solution into the CLEAN WATER TANK
and replace the lid. Turn clockwise to tighten. Place the CLEAN
WATER TANK back in the machine, making sure it is secure.
4. Check the POWER SWITCH to make sure it is in the "off" position.
5. Unwrap the POWER CORD and plug in to an outlet. Note: Rotate the
top CORD WRAP HOOK to release the cord for easy unwrapping.
6. To clean RUG/CARPET position the machine and turn the POWER
SWITCH toward the "RUG" setting.
7. Depress the "SOAP & SCRUB" button on the top of the handle while
pulling the machine slowly and steadily backward in a straight line.
(Fig. 4)
8. Use the SUPER BOOST SPRAY knob to select your desired level of
deep cleaning. (Fig. 5). For moderately/heavy soiled or high-traffic
carpets set the SUPER BOOST SPRAY to "ON". (See SUPER BOOST
CLEANING instructions found on Page 7 for more information).
9. Release the "SOAP & SCRUB" button 6 to 12 inches before ending
each pass to stop cleaning solution. Tilt the machine back and push it
forward to start a new backward cleaning pass.
10. When the "CLEAN WATER TANK" is empty, re-fill using the TANK
REFILLING instructions found on Page 8.
11. To clean upholstery, stairs, spots and stains see the UPHOLSTERY
TOOL instructions found on Page 9.
12. Wrap the UPHOLSTERY TOOL around the TOOL CADDY. The TOOL
CADDY is removable and can be stored on-board or hung on a hook.
See Page 5 for UPHOLSTERY TOOL CADDY wrapping instructions.
4
rugdoctor.com 1-800-784-3628
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
(Fig. 5)