Meec tools 017945 Mode D'emploi page 28

EN
DESCRIPTION
Powerful electric planer with innovative cutter
consisting of 3 double edged blades. The
blades are reversible, which means that both
sides can cut. The planer has a built-in shavings
extractor and bag, but can also be connected
to an extractor/vacuum cleaner. Supplied with
parallel fence, depth stop, dust bag and 1 extra
drive belt.
1. Adjuster knob for bit depth
2. Alignment knob for extraction
3. Power switch
4. Lock knob for power switch
5. Threaded fixture for fence
6. Bag
7. Open-end spanner
8. 3 nuts
9. Screws with wing nuts
10. Hex key
11. Fence
FIG. 1
USE
WARNING!
Read all the safety instructions and
familiarise yourself with the product before
use.
UNPACKING
Unpack all parts and place them on a level and
stable surface. Remove all packaging material
and any transport locking devices. Check that
all parts are included and undamaged. Make
sure not to lose any of the small parts.
28
STARTING/STOPPING
Switch on and switch off the product by
pressing and releasing the power switch (3). To
press the power switch the power switch lock
button (4) must be pressed first.
FIG. 2
ADJUSTING THE BIT DEPTH
Set the required bit depth with the adjuster
knob.
FIG. 3
IMPORTANT:
The maximum bit depth is 3 mm – do not
attempt to increase this depth.
REPLACING PLANING BITS
1. Undo the three nuts holding the planing
bits in place with a spanner.
2. Press out the planing bits from the steel
holder with a small screwdriver.
3. Insert the new planing bits and tighten
the three screws.
FIG. 4
MAINTENANCE
WARNING!
Switch off the product and pull out the plug
before checking, cleaning, maintenance
or adjustments, and before replacing
accessories.
IMPORTANT:
Maintenance, adjustments, inspection and
replacement of carbon brushes, including
any repairs must only be carried out by an
authorised service centre or other qualified
personnel using identical spare parts.