Installation Of Wall Anchors Or Screws - Beyond LAUNDRY PRO 2.0 Manuel De L'utilisateur

INSTALLATION OF WALL ANCHORS OR SCREWS

1 . Place the Laundry Pro 2 .0 to the wall and mark the appropriate keyholes
with a pencil .
NOTE:
Washing machine and cold water faucet must
be within 4 feet (1 .21 m) of the right side of unit .
A . If using supplied wall anchors, drill two 3/16" (4 .76 mm) diameter holes .
Place two wall anchors into the wall . Install two supplied screws and tighten
until almost all the way in .
B . If mounting to wall studs, drill two 3/32" (2 .381 mm) diameter holes
approximately 1" (25 .4 mm) deep . Install two supplied screws and tighten
until almost all the way in .
NOTE:
The provided hardware kit contains adhesive backed rubber spacers
to be placed on back of unit to provide additional clearance from
wall if needed for hose installation or the use
of Active Clean Port . (Page 13)
2 . Position the keyholes of the Laundry Pro 2 .0 onto the screws (not
shown) . Finish tightening screws enough to securely mount unit, but
still allowing it to be removed from wall . Remove unit from wall .
6
Screws (not shown)
17 .3" (43 .94 cm)
Keyholes