Installation Requirements - Beyond LAUNDRY PRO 2.0 Manuel De L'utilisateur

INSTALLATION REQUIREMENTS

ELECTRICAL REQUIREMENTS
100 - 240 Volt 50/60 Hz 5 AMP (minimum) Fuse or Circuit Breaker .
Laundry Pro 2 .0 is equipped with an AC to DC power supply .
NEVER USE AN EXTENSION CORD.
WATER REQUIREMENTS
A dynamic water pressure of greater than 20 psi / 1 .37 bar and less than
60 psi / 4 . 1 3 bar is required to correctly operate your Laundry Pro 2 .0 .
See Cautions below .
CAUTION:
Incoming water pressure must be greater than 20 psi / 1 .37 bar . If your
household water pressure is greater than 60 psi / 4 . 1 3 bar, you must
install an in-line pressure reducer before installing Laundry Pro 2 .0 .
Failure to follow these instructions may result in water leakage, property
damage, personal injury, and may void your warranty . Water pressure
of 20 psi / 1 .37 bar to 60 psi / 4 . 1 3 bar is required to correctly operate
your Laundry Pro 2 .0 . Low water pressure may prevent your unit from
operating properly and/or cause a failure in your washing machine's
water valve .
5 .19" (13 .48 cm)
4
17 .3" (43 .94 cm)
3 .69" (9 .37 cvm)
LOCATION CONSIDERATIONS
The Laundry Pro 2 .0 must never be installed in areas where water
may freeze since the unit will always maintain some water in the unit,
the water valve, and hose areas . This can cause damage to internal
components . It is also recommended to avoid installation in areas of
high humidity, as it can effect the operation of the unit .
The washer's water valve may also not shut off completely . Check
the documentation supplied with your washing machine for exact
specifications . Your washing machine and cold water faucet must be
within 4 feet of the right side of the unit to use the inlet hose provided
with your Laundry Pro 2 .0 .
TO AVOID THE POSSIBILITY OF WATER DAMAGE, SHOULD A HOSE
LEAK, ALWAYS HAVE FAUCETS ACCESSIBLE AND TURN OFF
FAUCETS WHEN WASHER IS NOT IN USE. DO NOT USE WITH A
CARBON FILTER.
WATER
INLET
WATER
OUTLET