Water Plus; Fabric Softener; Extra Rinse - Midea MLV45N1BWW Manuel D'utilisation

3
Digital display
The initial display is the total time for the cycle you select.
While your washer is running, the display shows the cycle process and
time remaining in the cycle.
NOTE: the time shown is an estimate based on normal operating conditions.
External factors (such as the load size, room temperature, incoming water
temperature, and water pressure) can affect actual time.
If you set a delay time for the start of the cycle, the display shows the time
when the cycle will start.
4
SOAK
Press to select the SOAK option. Press again to cancel. Select this option
for heavily soiled items that need to soak to remove stains and heavy dirt.
Soak occurs after the tub fills and detergent is added, but before the wash
process. The agitator or impeller will rotate seral times during the soak
process.
5
Delay
Press to select a time when you want the cycle to begin. You can set the
time up to 24 hours in advance in one-hour increments. The display shows
the time when the cycle will start. For more information, see Set a delayed
start time on page 32.
6
MY CYCLE
Press and hold for 3 seconds to remember your favorite washing cycle.
Press once to load your favorite cycle settings.
7
START PAUSE
Press once to start the wash cycle. Press again to pause the cycle. If you
pause the cycle, you can add or remove items, but you cannot change any
settings. Press again to restart the cycle.
8

WATER PLUS

Press once to increase one higher water level. Press again to cancel this
function. If the water level is already set to the highest, the level will not
change.
9

FABRIC SOFTENER

Add liquid fabric softener to the fabric softener compartment, and then
press this button. The fabric softener will be added to the cycle at the
correct time.
10

EXTRA RINSE

Press to add an extra rinse to the wash cycle. Press again to cancel.
28