Rowenta IS6200 Mode D'emploi page 23

1800124023 IS6200 US_110X154 22/09/11 10:20 Page21
Crease attachment
• Remove the fabric brush. Completely slide the hook
of the accessory into the slot located in the lower part
of the steam head.
• Push on the handle to open the crease attachment.
• Place the garment between the crease attachment and
steam head.
• Release the handle.
• Starting at the top of the garment, move the crease at-
tachment in a downwards motion.
• Once unit is unplugged and completely cooled down,
remove the crease attachment by sliding it off of the
steam head.
Lint pad
The lint pad is a separate accessory and cannot be attached to the steam
head.You can use the lint pad independently from the steamer.
The lint pad removes hair, lint and animal fur for a professional finish.
• To use the lint pad, slowly brush the clothing with the grain or nap of
the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We re-
commend cleaning the pad on an old cloth that can be discarded.
FTER USE
• fter using the garment steamer, switch off the device by pressing the
pedal once again. The power indicator light will go off, and you can then
unplug the device.
• Hang the steam head in an upright position on the hook when not in use.
• Empty and rinse the water tank each time before storage in order to flush
out any scale particles. (fig.15)
• Loosely wind up the electrical cord and close with the Velcro strip, then
hang it from the clip on the pole. (fig.16 , 16b)
• Do not carry the steamer by the water tank handle. This appliance includes
luggage style wheels for added convenience when transporting.
Warning: Never touch the steam head until it has cooled down
completely.
21