Rowenta IS6200 Mode D'emploi page 20

1800124023 IS6200 US_110X154 22/09/11 10:20 Page18
- To avoid a circuit overload, do not operate another high wattage
appliance on the same circuit. If an extension cord is absolutely
necessary, a 15-amp rated cord should be used. Cords rated for
less amperage may overheat. Care should be taken to arrange
the cord so that it cannot be pulled or tripped over.
S VE THESE INSTRUCTIONS
ENVIRONMENT L PROTECTION FIRST !
i Your appliance contains valuable materials which can be re-
covered or recycled.
‹ When disposing of it, take it to a collection point or an approved
service center.
DESCRIPTION
1. Steam head
2. Steam head hook
3. Built in hanger
4. Trouser/dress clips
5. Hanger holder
6. Pole locking clips
7. Electric cord holder
8. Electric cord
9. Velcro strip
10. Telescopic pole
11. Pole fastening screw
G RMENT STE MER SSEMBLY
Pole and hanger assembly
1. Unscrew the pole's fastening screw on the base of the pole. (fig. 1)
2. Hold the pole such that the cord holder is on the left. Check that the 2
pole clips are unlocked. (fig. 2)
3. Insert the pole into the base by pressing downwards until the holes of
the pole and base are at the same level, so that you can put the screw
back. If the holes are not aligned, check that the clips of the pole are well
and truly unlocked. (fig. 3)
SPECI L INSTRUCTIONS
12. Steam hose connector
13. Removable water tank
14. ON/OFF pedal
15. Transport wheels
16. Textile steam hose
17. On/ off light
18. Built in accessories
18
a. Fabric brush
b. Crease attachment
c. Lint pad