Rowenta IS6200 Mode D'emploi page 22

1800124023 IS6200 US_110X154 22/09/11 10:20 Page20
may be suspended from the hook located on the hanger rod. To steam
trousers, we recommend that you also use the support with clips as in-
dicated in the illustration. (fig.14)
• Grasp the steam head with the steam vents pointing away from you.
• Start steaming by brushing material lightly with the grain of the fabric
in an up/down vertical motion. The fabric brush opens the weave of the
fabrics for better steam penetration.
• Start at the top the garment and gradually move downward (fig.13).
lways steam in a vertical position.
• For more ease, we recommend to pull the garment downward with your
free hand while steaming. Be careful not to touch the hot steam.
• During use, the hose may make a gurgling noise. This is a normal oc-
currence due to condensation. If the device begins to gurgle, rest the
steam head on its support for a few moments in order to direct the
condensation into the device once again.
CCESSORIES
Before using an accessory, check the manufacturer recommendations.
It is also recommend that you carry out a test on part of the fabric which
cannot be seen.
Fabric brush
The fabric brush opens the weave of the fabrics for better steam pene-
tration.
Be sure unit is unplugged and completely cool before attaching
accesories.
• ttach the fabric brush to the steam head by lining up
the bottom of the brush with the bottom of the steam
head. Gently push the top of the brush onto the
steam head until it clicks into place.
• Gently brush the area to be steamed with the grain or
nap of the fabric.
• Remove the fabric brush once unit is unplugged and
completely cool. Remove it by pressing on the release
tab on top of brush while pulling it forward.
20