Basic Arc Measurements; Advanced Users - Paradigm Founder Serie Mode D'emploi

ANTHEM ROOM CORRECTION (ARC) – Founder 120H Only (cont'd)
BASIC ARC MEASUREMENT
1. With your microphone set in Position One, the "main measurement position," use the
USB to connect both the microphone and the ARC-ready equipment being measured to
a USB input on your computer.
2. Run ARC by selecting it from the Start Menu. The program will guide you through the
measurement steps. At the end of the process, ARC will automatically load the room
correction data to your equipment. The process takes about 10 minutes depending on
the number of measurements.
3. You can name the measurement data file saved to your computer. Up to 16 characters
may be used to name a measurement. Additional characters will be removed. Valid
naming characters are: a-z, A-Z, 0-9, " ", "-", ".", ":", ";", "<", "=", ">", "?", and "@". Other
characters will not be allowed.
4. Once the ARC program is finished, you can disconnect your computer. You can break
down and store the microphone set safely for future use.
• If the positions of your speakers change, or if new furniture or other sound-reflective
materials are introduced into the room, or your main listening position changes, you will
have to re-measure.

ADVANCED USERS

One of the incredible features of ARC is that it gives you the tools to customize your room
response curves. This is recommended only for more advanced users.
For the latest instructions for advanced users, please visit anthemav.com/arc.
17