Microphone Positioning & Connection; Pairing - Paradigm Founder Serie Mode D'emploi

ANTHEM ROOM CORRECTION (ARC) – Founder 120H Only
MICROPHONE POSITIONING & CONNECTION
To adjust the length of the telescoping tube, first loosen its clamp by rotating it
counterclockwise; reposition, then rotate clockwise to lock. Set the microphone in
the first position. Don't stand near the microphone while sweep tones are playing,
otherwise, reflections from your body may cause bad measurements.

PAIRING

Founder 120H speakers have the ability to be set up as a pair. Once you pair two
Founder 120H speakers, you will be able to connect to both speakers simultaneously
to run ARC either via Bluetooth or USB connection.
All Founder 120H speakers start as a "Left" speaker from the factory and are
automatically looking to pair with a "Right" speaker. To set up a pair of 120H to run
ARC on, you need to set one up as a "Right" speaker. Speakers can only be paired if
they also share the same name.
When pairing multiple sets of 120Hs, you will need to use a different name for the
additional pairs of speakers. You can custom name your Founder 120H speakers up
to14 characters, as long as it matches the speaker that it is intended to pair with.
If using an odd number of speakers (ex: one as a center channel), follow the steps
below but rename it to something different in the pairing menu so it won't attempt to
pair with the "Right" speaker.
14
1
(cont'd)
During all measurements,
the microphone must point
straight up.
The microphone's height
is critical to proper
measurement. The
microphone should be
positioned at ear-level
when seated and should
correspond with the height
of the high-frequency
drivers in the front speaker
array.
Incorrect microphone
positioning may result
in a dull or bright sound.
Readjust the microphone
to seated ear-level in line
with the high-frequency
drivers and repeat ARC
measurements.