Remote Control Battery - Danby DBSH02213WD13 Manuel Du Propriétaire

OPERATING INSTRUCTIONS
REMOTE CONTROL
1. ON/OFF: Used to turn the heater on or off.
2. Mode button: Used to set the desired mode; fan,
low heat or high heat.
3. Oscillation button: Used to start and stop the
oscillation feature.
4. Timer button: Used to set the timer feature.
5. Up button: Used to increase the set temperature.
6. Down button: Used to decrease the set
temperature.
1
3
5

REMOTE CONTROL BATTERY

This remote control uses one CR2025 battery.
To remove the battery, push the latch on the battery
compartment upwards and then pull the battery tray
out.
To replace the battery, place the new battery in
the battery tray and push it gently into the remote
control until it clicks into place.
2
WARNING: Never dispose of batteries in fi re.
Failure to observe this precaution may result in
an explosion. Dispose of batteries at your local
4 hazardous material processing center.
If the heater will not be used for a long time, remove
the batteries to prevent corrosion. Store the remote
control in a safe place.
6
6
CR2025