Care & Maintenance - Danby DBSH02213WD13 Manuel Du Propriétaire

CARE & MAINTENANCE
CLEANING
1. Ensure the power is turned OFF and the heater
is unplugged.
2. Allow the heater to completely cool before
attempting any cleaning.
3. The outer shell may be cleaned with a soft,
damp cloth. A mild detergent can be used if
necessary.
4. After cleaning, dry the heater with a soft, dry
cloth.
5. Wait until the heater is completely dry before
using.
WARNING: Do not immerse the heater in water or
allow water to enter the heater.
WARNING: Do not use alcohol, gasoline, abrasive
powders, furniture polish or rough brushes to clean
the heater. This may cause damage or deterioration
to the surface of the heater.
STORAGE
Store the heater in a cool, dry location when not
in use. To prevent dust and dirt build-up, use the
original packaging to repack the heater.
TROUBLESHOOTING
If the heater will not operate, check the following:
1. Check that the power cord is plugged into a
120 V AC electrical outlet. Do not use extension
cords.
2. Check that the power indicator light on the
control panel is illuminated to show that the
heater is getting power from the outlet.
3. Check if the battery in the remote control needs
to be replaced.
4. Unplug the heater, wait 15 minutes for the
internal components to reset and then plug it
back in.
5. Ensure that the heater is placed on a fl at, fi rm
surface and that the tip over switch is engaged.
8