Important - Danby DBSH02213WD13 Manuel Du Propriétaire

OPERATING INSTRUCTIONS
INSTRUCTIONS FOR USE
1. Place the heater on a fi rm, level surface. Only
use the heater in an upright position.
2. Pull out the insulating fi lm from the remote
control battery compartment.
3. Ensure the power is turned OFF.
4. Plug the heater directly into a 120 V AC
electrical outlet.
5. Turn the heater on by pressing the power button.
6. Press the mode button to set the desired mode.
7. Press the up and down arrows to set the desired
temperature. The temperature can be set
between 15C - 30C (59F - 86F). The heater will
remain on until the set temperature is reached
and it will then cycle on and off to maintain the
set temperature.
8. Turn the heater off by pressing the power button.
When the power is turned off the heating
element will stop working immediately but the
fan will continue to run for 30 seconds or until
the heater has cooled.

Important

When the heat feature is used for the fi rst time,
a slight odor may be present. This is normal and
should not occur again unless the heater is not used
for an extended period of time.
It is normal for the heater to cycle on and off as it
maintains the set temperature.
For the heater to function properly, the set
temperature must be higher than the ambient
temperature in the room. If the heater does not
seem to be heating, increase the set temperature to
engage the heating element.
Press and hold the mode button for 3 seconds to
change the display temperature between C and F
temperature scales.
IMPORTANT WARNING
Do not leave this appliance unattended in a
space where people or animals who cannot
react to a malfunction are located. A malfunction
can cause extreme overheating or death in an
enclosed, unattended space.
OSCILLATION
Press the oscillation button to begin the oscillation
feature. The heater will oscillate back and forth
while this feature is in operation. Press the
oscillation button again to stop the oscillation
feature.
TIMER
The timer feature can be used to set the heater to
turn off after a set amount of time. The timer can
only be set while the heater is turned on. The timer
cannot be used to turn the heater on.
To set the power off timer:
1. Ensure the heater is turned on.
2. Press the timer button. The LED display will
change to show hours instead of temperature.
3. Press the timer button repeatedly to set the
number of hours that the heater should run
before turning off. The timer can be adjusted in
1 hour increments to a maximum of 12 hours.
4. The LED will fl ash the selected time for a few
seconds and then will return to showing the
temperature. The timer indicator light will
remain illuminated while the timer is active. The
heater will automatically turn off when the timer
reaches zero.
7