Remote Control Battery - Danby DBSH01113WD13 Manuel Du Propriétaire

OPERATING INSTRUCTIONS
REMOTE CONTROL
1. ON/OFF: Used to turn the
heater on or off.
2. Mode button: Used to set the
desired mode; fan, low heat
or high heat.
3. Oscillation button: Used to
start and stop the oscillation
feature.
4. Timer button: Used to set the
timer feature.
5. Up button: Used to increase
the set temperature.
6. Down button: Used to
decrease the set temperature.
1
3
5

REMOTE CONTROL BATTERY

This remote control uses one CR2025
battery.
To remove the battery, push the latch
on the battery compartment upwards
and then pull the battery tray out.
To replace the battery, place the new
battery in the battery tray and push it
gently into the remote control until it
clicks into place.
WARNING: Never dispose of
batteries in fi re. Failure to observe
this precaution may result in an
2
explosion. Dispose of batteries
at your local hazardous material
processing center.
If the heater will not be used for a
long time, remove the batteries to
prevent corrosion. Store the remote
4
control in a safe place.
Keep batteries out of childrens'
reach. Discard them carefully.
Do not allow children to play with
batteries.
6
Never put button batteries in or near
your mouth for any reason, they
are slippery and easy to swallow
accidentally.
8
CR2025