Programming The Remote - Toshiba 44HM85 Manuel D'utilisation

Programming the Remote

The remote control for your HD receiver is a
multi-brand or universal remote control that can
be programmed to operate most remote-control-
lable devices of other manufacturers.
Note: The remote control may not be able to con-
trol all models of other brands.
Test your remote control.
1
To find out whether your remote control can
operate the device without programming,
turn on the device such as a the VCR and
press the corresponding mode button (VCR)
on the remote control while pointing at the
device. Test the POWER and CH
to see if the device responds properly. If
not, the remote requires programming to
operate the device.
Turn on the device to be programmed. Then
2
press the corresponding mode button on the
remote control.
Press the POWER button and the MUTE but-
3
ton simultaneously. Now the remote control
is ready to program the code for the corre-
sponding device.
There are two ways to find the right code for
4
the device.
A. If you press the CH
edly, the codes will change one at a time.
Press the POWER button after each code
change. If the right code is found, the
device will turn off.
B. Enter a code number using the number
buttons on the remote. The right code num-
bers for the corresponding component can
be found on the following pages.
Again, if the code is correct, the device will
turn off.
Press the EXIT button to store the program.
5
Test the remote control functions to see if
6
the device responds properly. If not, repeat
from step 2.
buttons
D / E
buttons repeat-
D / E
VCR CABLE DVD SAT
TV
MODE
LIGHT
2
TV/VIDEO FRONT
C/S HD1 C/S HD2
1 2
4
4 5
7 8
0
ENTER
VOL
MUTE
3
SAP
PIP PIPCH- PIPCH+
CC
PIC SIZE
MENU
PLAY
PAUSE
REW
FF
POWER
3
HDMI
RGB
3
6
9
CH RTN
CH
SURF
VIDEO
4
SWAP
FREEZE PIP INPUT
EXIT
5
STOP REC
SKIP
P A G E 4 9