Toshiba 44HM85 Manuel D'utilisation page 48

Lamp Unit Replacement(Contd.)
6. Pull out the handle slowly and remove the lamp case.
7. Insert the new lamp gently into the correct position. Make sure it is inserted correctly.
Note:
• Never subject the lamp unit to excessive shock.
• Never touch the lamp unit glass or otherwise get it dirty.
Doing so may affect the image quality and reduce the service life of the lamp. See " Cleaning the
lamp unit glass" at below.
Cleaning the lamp unit glass
If you accidentally touch the lamp unit glass or otherwise get it dirty, wipe it with a lint-free
lens cleaning cloth (such as a cloth for cleaning camera lenses or eyeglasses).
8. Using a manual Phillips screwdriver (Do Not use an electric screwdiver), tighten the screws you removed in
step 3.
9. Replace the lamp cover and tighten the cover screws.
NOTE:
TV may not turn on.
10. Plug in the power cord and turn on the TV. After the initial warmup period (which may take up to several
seconds for full picture brightness), the TV should operate normally. If any of the following conditions exist,
turn off the TV, unplug the power cord, and repeat steps 1–9 to ensure that the lamp unit and lamp unit
door are installed correctly:
• The lamp indicator flashes green.
• No picture
• Dark picture
• TV will not turn on
If, after repeating steps 1–10, the problem still exists:
• In Canada, locate the nearest Toshiba authorized service depot by directing your web browser to
www.toshiba.ca; click "Home Entertainment," and then click "Support."
CAUTION
: NEVER clean a hot lamp with any type of flammable liquid or
aerosol cleaning agent. Many ordinary cleaning agents (such as glass
cleaners) contain chemicals that may be flammable at certain tempera-
tures. If the lamp unit is not allowed to cool for at least one (1) hour,
such chemicals may lgnite.
Make sure the lamp unit and door are installed securely; otherwise, the
P A G E 4 7