Select And Start A Washing Programme - AEG FAVORIT 44010 VIL Notice D'utilisation

18

Select and start a washing programme

Select and start a washing programme
Select the washing programme and delay start with the door slightly opened. The start of
the programme or the countdown of the delay start will occur only after the closure of the
door. Until then it is possible to modify the settings.
1. Check that the baskets have been loaded correctly and that the spray arms are free to
rotate .
2. Check that the water tap is opened.
3. Press the On/Off button: all the programme lights illuminate (setting mode).
4. Press the button corresponding to the required programme (see "Washing programmes"
chart). The light corresponding to the selected programme will illuminate.
Close the dishwasher's door, the programme starts automatically.
Setting and starting the programme with "delay start"
1. After having selected the washing programme, press the delay start button until the
light corresponding to the chosen hours flashes (3h, 6h or 9h).
2. Close the dishwasher's door, the countdown starts automatically.
3. The countdown will decrease with steps of 3 hours.
4. The opening of the door will interrupt the countdown.
5. Once the delay start has elapsed the programme will start automatically.
Cancelling the "delay start" and / or a washing programme
• To cancel a delay start in progress you have to reset the dishwasher.
• Cancelling a delay start involves also the cancelling of the washing programme set. In
this case you have to set the washing programme again. If a new washing programme
is to be selected, check that there is detergent in the detergent dispenser.
WARNING!
Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary.
Attention! Hot steam may escape when the door is opened. Open the door carefully.
Interrupt a washing programme in progress:
• Open the dishwasher door; the programme will stop. Close the door; the programme will
start from the point at which it was interrupted.
• Press the On/Off button, all lights will turn off. Press the On/Off button again; the pro-
gramme will start from the point at which it was interrupted.
End of the washing programme
• The dishwasher will automatically stop.
• The audible signal will inform you of the end of programme.
• Open the dishwasher door.
• The end of programme indicator light will illuminate.
• The light of the programme just ended will remain on.
1. Switch off the dishwasher by pressing the On/Off button.
2. Open the dishwasher door, leave it ajar and wait a few minutes before removing the
dishes; in this way they will be cooler and the drying will be improved.