Keep Warm Mode; Standby Mode / Reactivation Of The Device; Cleaning And Maintenance; Safety Information - CASO DESIGN WK Cool-Touch Mode D'emploi

16.3 Keep warm mode

After heating operation the device automatically switches to keep warm mode.
If 95° or 100°C were set then the keep warm temperature is 90°C. Otherwise the keep
warm temperature is the set temperature.
After 30 minutes without further operaeton the device will beep 5 times and switches to
standby mode, the display and buttons are not illuminated anymore.

16.4 Standby mode / reactivation of the device

The device can be reactivated from standby mode, by taking the kettle from the base or by
pressing of any button.

16.5 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

16.6 Safety information

Please observe the following safety notices, before you commence with cleaning the
device:
► The WK Cool-Touch must be cleaned at regular intervals and calcium deposits should
be removed.
► Switch the device off prior to cleaning it and unplug the plug from the wall power outlet.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
► Do not immerse kettle, base or power cord in water.

16.7 Cleaning

 Kettle
 Rinse the kettle with a damp cloth.
 Mesh
 The mesh is located it the sprout of the kettle. Clean it with a toothbrush.
 Base
 The stainless steel surface of the base can be cleaned with a commercial stainless steel
cleaning agent.
 Buttons
 Clean the buttons with a damp cloth. Do not use cleaning agents.
Attention
30