13.2 Delivery scope and transport inspection
As a rule, the WK Cool-Touch is delivered with the following components:
Kettle
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
13.3 Unpacking
To unpack the device, proceed as follows:
Remove the device out of the carton and remove the packaging material.
13.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.
13.5 Setup
13.5.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity for the WK Cool-Touch.
Place the device only on a waterresistent surface.
Choose the setup location in such a way that children cannot reach any hot surfaces on
the device.
The device is not intended to be installed in a wall or a built-in cupboard.
Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
Base with cord
Please note
Please note
Operating Instructions
26