General Safety Information - CASO DESIGN WK Cool-Touch Mode D'emploi

12.2 General Safety information

Please observe the following general safety notices with regard to the safe handling
of the device.
► Examine the device for any visible external damages prior to using it. Never put a
damaged device into operation.
► If the connection lead is damaged, you will need to have a new connection lead
installed by an authorized electrician.
► This appliance can be used by children aged 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
► Children shall not play with the appliance.
► Cleaning and user maintenance shall not be made by children without supervision.
► Do not leave the device unsupervised when it is in operation.
► Keep the appliance and its cord out of reach of children less than 8 years.
► Do not operate the WK Cool-Touch when it is empty. This can damage the devise.
► If the kettle is full there is a risk that boiling water squirts out, which can lead to burns or
scalding. Therefore never fill the kettle beyond the maximum mark.
► The water kettle is intended to heat water only. It is not designed to be used for cooking
food or for heating any other fluids.
► The cord shall not come into contact with the hot parts of the device.
► Never immerse the device, cord or plug in water or other liquids and do not place in the
dishwasher.
► Operate the device only with the supplied base.
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs that may be needed. Improperly performed repairs can cause considerable
dangers for the user.
► Only customer service departments authorized by the manufacturer may carry out
repairs on the device during the guarantee period, as otherwise the guarantee
entitlements will be null and void in the event of any subsequent damages.
► Defective components must always be replaced with original replacement parts. Only
such parts will guarantee that the safety requirements are fulfilled.
Please note
24