Load Ribbon Cassette - Valentin DYNACODE IP Guide De Démarrage Rapide

Dynacode IP

Load Ribbon Cassette

NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be damaged,
the transfer ribbon should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.
Ribbon Coating Outside
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be cleaned using printhead and roller cleaner
(97.20.002).
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure good
ventilation.
Ribbon Coating Inside
124
The illustration shows a left hand printing system. If you are using a right hand
system, then the new roll is to be inserted at the left and the cardboard core is
to be inserted at the right side.
•
Turn the lever (A) 90° in clockwise direction.
•
Remove the ribbon cassette from the print mechanics by pulling the
handle (B).
•
Load a new ribbon roll as far as it will go onto the unwinding roll (C).
•
Load an empty cardboard roll as far as it will go onto the rewinding unit
(D).
•
Insert the ribbon according to illustration.
•
Fix the ribbon with an adhesive tape at the empty roll and tighten it by
some turns of the core.
•
Push the ribbon cassette again onto the print mechanics and take care
that the ribbon not rip.
•
Turn the lever (A) 90° anticlockwise.
CAUTION!
Impact of static material on people!

Use antistatic transfer ribbon, because static discharge can
occur when removing.
The illustration shows a left hand printing system. If you are using a right hand
system, then the new roll is to be inserted at the left and the cardboard core is
to be inserted at the right side.
•
Turn the lever (A) 90° in clockwise direction.
•
Remove the ribbon cassette from the print mechanics by pulling the handle
(B).
•
Load a new ribbon roll as far as it will go onto the unwinding roll (C).
•
Load an empty cardboard roll as far as it will go onto the rewinding unit
(D).
•
Insert the ribbon according to illustration.
•
Fix the ribbon with an adhesive tape at the empty roll and tighten it by
some turns of the core.
•
Push the ribbon cassette again onto the print mechanics and take care that
the ribbon not rip.
•
Turn the lever (A) 90° anticlockwise.
CAUTION!
Impact of static material on people!

Use antistatic transfer ribbon, because static discharge can
occur when removing.
English