Troubleshooting - Inventum AKD9015GTZ Manuel D'utilisation

1. Open the cover of the appliance.
2. Push the latch (A).
3. Support the grease filter (B) and remove it from the appliance.
4. Clean the grease filter. Use hot water and a mild cleaning agent.
5. If necessary, clean the grease filter in a dishwasher. Use a program with a low temperature.
Note:
The grease filter can change color after cleaning. This is normal.
6. Make sure that the grease filter is dry before installing.
REPLACING THE CARBON FILTER (OPTIONAL)
Note:
The grease filter must be replaced when the display shows C (after 100 hours of operation) or every 4
months.
Note:
This procedure is only valid if you installed the carbon filter with your appliance.
1. Open the cover of the appliance.
2. Remove the grease filter.
3. Replace the carbon filter (A).
4. Install the grease filter.
REPLACING THE LAMP
Preliminary requirements
• Lamp 2 W LED L27A (2x)
Procedure
1. Remove the grease filter.
2. Push the lamp (A) down.
3. Carefully remove the connector (B) from the transformer.
4. Replace the lamp with a new one.
5. Connect the connector to the transformer.
6. Install the lamp.
7. Install the grease filter.
8. Repeat the steps for the second lamp.
RESETTING A SATURATION INDICATOR
The control of the appliance shows an indicator on the display for certain cleaning and replacing intervals.
1. Make sure that the appliance is switched off.
2. Touch the timer button for a few seconds to reset a saturation indicator.
7

Troubleshooting

GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table.
2. If you cannot find a solution for the problem, contact the Inventum-servicedienst.
(Figure 13)
(Figure 14)
(Figure 15)
English • 35