Pool Vacuum Assembly / Operating Instruction - POOL Prompt Set Manuel D'instructions

POOL VACUUM OPERATING INSTRUCTIONS
1. Connect the garden hose to the water spigot and turn on the water
NOTE: The water pressure varies in each community so testing will have to be
done to find the correct hose water pressure for optimum cleaning.
2. In soft gentle strokes "sweep" the entire bottom surface of the pool until it is clear
of debris.
3. Turn water "OFF", remove the pool vacuum from the pool, disconnect and place
the garden hose in a safe area.
4. Untie, empty and clean the debris collection bag. Allow the debris bag to air dry.
Re-tie the collection bag on to the cleaning head.
5. Store the pool vacuum in an area where it will not be a safety hazard.
POOL VACUUM ASSEMBLY INSTRUCTIONS
1. Assemble the shaft pieces by inserting them one into another.
2. The cleaning head (M-3) has a plastic spring (M-4) that connects to the
bottom shaft. Align the plastic spring located inside the cleaning head with
the holes drilled in the shaft. Gently squeeze together the plastic spring tips
so that the shaft slips onto the cleaning head and the spring "pops" into the
pre-drilled holes.
3. Remove paper protector sleeve from brush (M-6) and snap into locked
position on underside of cleaning head (M-3).
4. Tie the debris collection bag (M-2) onto the cleaning head opening
opposite from the garden hose connection, as you would tie shoelaces.
5. Depending on the type of garden hose connect the hose to the side opposite
the debris bag.
IMPORTANT: The flat washer (M-5) must be placed into coupling
before garden hose is connected.
6. Secure hose to pole by inserting into hose clamp (M-1) included with kit.
7. The pool vacuum is now ready to use.
13