Relay For Lock Release; Configuration (V2Plus System) - golmar SAR-2PLUS Manuel D'installation

42

Relay for Lock release:

To configure the relay unit as AC Lock release:
Set JP1 system selection jumper for 2PLUS system (see page 38).
Set SW1-2 of the relay unit to ON (see page 38).
SAR-2Plus relay unit will be activated together with the Lock release of the door panel during
call reception or communication process by pressing push door release button of any phone of
the backbone where the relay unit is installed.
BUS
SAR-2PLUS
SW1
JP1
E.of LINE BUS BUS
CONFIGURATION
TF-104
PRI SEC
~ ~ ~ ~
Main
AC Lock release