System Selection Jumper - golmar SAR-2PLUS Manuel D'installation

38
D
escription of the configuration microswitch.
The configuration microswitch SW1 is located on the botton left
of the SAR-2Plus unit.
Leave all OFF to configure the unit as a bus relay (see page 36).
*Factory default.
D
escription of the system selection jumper.
The selection jumper JP1 is located on the botton left
of the SAR-2Plus unit.
Insert the jumper in this position if the unit is installed in a
JP1
2Plus Door Entry System.
Audio
Insert the jumper in this position if the unit is installed in a V2Plus Door Entry
JP1
System.
Video
*Factory default.
Set to ON to configure SAR-2Plus unit as additional call repeater
(see page 35).
Set to ON to configure SAR-2Plus unit as relay for Lock release
(see page 35).
Set to ON to start programming mode (only to configure SAR-
2Plus unit as additional call repeater).
Once programming is finished set to OFF.
No function.
INSTALLATION