Denver DAB-36 Mode D'emploi page 3

POWER SUPPLY
OPERATING THE UNIT ON AC POWER
Insert one end at the supplied power cord to the DC 7.5V IN Jack located at the rear of
the unit and the other end into the Wall outlet.
When the First time used the cord has to be firmly pushed into the socket if does not
work on AC, to try again to be sure for a positive connection.
OPERATING THE UNIT ON BATTERIES
To play your unit on batteries, the AC power cord must be disconnected from the player.
Unplug the AC power cord from the unit and insert 4 size "C" batteries (not provided) in
the compartment.
Close the battery compartment door.
Note: Check your batteries regularly. Old or discharged batteries should be replaced. If the
unit is not to be used for sometime or is being run exclusively on AC electrical current,
remove batteries from the battery compartment to avoid leakage.
Warning: Before using the unit. Check that the local mains supply is compatible with the
Unit Do not plug or unplug the power cable when your hands wet.
When planning not to use this unit for long periods of time (i.e. Vacation etc.) disconnect
the plug from the wall outlet.
BATTERY SAFETY PRECAUTIONS:
Keep batteries away from children and pets.
ENG 3
Insert the batteries observing the proper polarity (+/-). Failure to properly align the
battery polarity can cause personal injury and/or property damage.
Remove old or discharged batteries from the product. Remove the batteries when the
product will not be used for extended periods of time to prevent damage due to rusted or
corroded batteries.
Never throw batteries into a fire, do not expose batteries to fire or other heat sources.
Battery Disposal: Old or discharged batteries must be properly disposed of and recycled in
compliance with all applicable laws. For detailed information, contact your local solid
waste authority.
Follow the battery manufacturer's safety, usage, and disposal instructions.
OPERATION
Press the Standby button to turn the unit.
IN DAB MODE
Press the DAB/FM/AUX/BT button to select DAB radio mode
Auto select : Press the SCAN button, "AUTOTUNE FULL SCAN" will show on the display,
and the number of DAB station will shown on the upper right corner, and it will
automatically play the first station. Tune the TUNE/SELECT knob to choose the next or
previous station.
Manual select: Press and hold the TUNE/SELECT knob until the "MANUAL TUNE" icon
shown on the display, then tune the TUNE/SELECT knob to choose the station.
Note : you many have to wait for the unit to tune in to the new channel.
DAB Radio stations presetting:
ENG 4