Midea NY2513-13A1L Mode D'emploi page 18

[Level Switch]
Under normal mode, repeatedly press the knob (or remote controller button) to
switch between High (orange) --- Middle (red) --- Low (green) --- OFF --- High
(orange).
[Temperature Setting]
Under normal mode, press the button to check the current setting temperature,
and the temperature icon flashes. Turn the knob to adjust the setting temperature,
it will automatically exit the enquiry setting interface if it is not operated within 3s,
and display the setting temperature.
[Timing ON]
Under OFF state, press the button (or remote controller button) to enter into
the timing enquiry interface, the setting time and timing icon flashed, turn the
knob to adjust the setting time, it will automatically exit the enquiry setting interface
if it is not operated within 3s. When the setting is 0, it cancels timing ON.
After reaching the timing ON time, the heater automatically turns on and works at
the last standby state. The time setting range is 0-24h, the adjustment unit in hour.
[Timing OFF]
Under ON state, press the button (or remote controller button) to enter into
the timing enquiry interface, turn the knob to adjust the setting time, it will
automatically exit the enquiry setting interface if it is not operated within 3s. When
the setting is 0, it cancels timing OFF. After reaching the timing OFF time, the
heater automatically enters into the standby state and stops work. The time setting
range is 0-24h, the adjustment unit in hour.
[Remote and ]
When working mode is on, press the button on control panel, press " " or
" " to adjust temperature within 5ºC to 35ºC. Press the button on remote
controller, press " " or " " to adjust time within 0 to 24 hours.
[Introduction on Mode]
Normal Mode : under this mode, the heater works at the setting level, after
reaching the setting temperature, it stops heating and the setting temperature
flashes.
Energy Saving Mode : under this mode, the heater works normally, the level
and setting temperature are not adjustable, the heater works at default setting
temperature(22ºC). (In Energy Saving Mode, if the setting temperature flashes, it
means the heater is under energy saving heat preservation work state). The
indicator light circle indicates green.
Anti-Freezing Mode : under this mode, press the knob to adjust the level, but the
setting temperature is not adjustable, the heater works at default anti-freezing
temperature(5ºC). (In Anti-Freezing Mode, if the setting temperature flashes, it
means the heater is under anti-freezing heat preservation work state). The indicator
light circle indicates red.
6