Operation - Midea NY2513-13A1L Mode D'emploi

WARNING: Risk of fire. Do not operate heater without wheel assemblies
attached. Operate heater in upright position only (wheels on bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions. It is not recommended that this heater be placed on
high-pile carpeting or any other surface that impedes the flow of air
underneath the heater.
This heater include an a visual alarm to warn that parts of the heater are
getting excessively hot. If the alarm flashes, immediately turn the heater
off and inspect for any objects on or adjacent to the heater that may
cause high temperatures. DO NOT OPERATE THE HEATER WITH THE
ALARM FLASHING.

OPERATION

Power on the heater, press the Power Switch at the lower side to ON position, the
power indicator lights on and buzzer makes sound to enter into the standby mode.
ON/OFF/LEVEL
[ON/OFF]
Under Standby Mode, press the
enters into the Normal Mode, works with highest power, and automatically set the
temperature at 35ºC, or recover to the state of the last standby state (Note: when
the power is not cut off). Repeatedly press the knob untill the heater recovers to the
Standby state.
[Mode Switch]
Under Working State, press the
heater switches between Normal Mode –fast-heating model -- Energy Saving Mode
--- Anti-Freezing Mode ---Normal Mode.
Power button
Mode
Temperature increase
Timing
Temperature decrease
Temperatur e Control
Indicator light
circle
knob (or remote controller
button (or remote controller
5
ON/OFF button
Timer button
Mode button
button), the heater
button), the