Samsung RS6N Serie Mode D'emploi page 52

Operations
04 Filter Reset (3 sec)
Filter Reset
05 Door Alarm / Vacation (3 sec)
Door Alarm
Vacation
Device
authentication
52 English
Untitled-10 52
After about 6 months (approximately 300 gallons) of using the original
water filter, the Filter indicator turns red to remind you that the filter
needs to be replaced. If this happens, replace the filter, and press and
hold Filter Reset for 3 seconds. The filter indicator will be reset, and
the Filter indicator turns off.
NOTE
Some regional areas have relatively large amounts of lime contained
in the water. This may reduce the lifecycle of the filter. In these areas,
you will have to replace the water filter more often than specified
above.
You can set the alarm for a reminder. If the door is left open for more
than 2 minutes, the alarm will sound with the alarm indicator blinking.
The alarm is enabled by factory default. To disable the alarm, press
Door Alarm. To enable, press Door Alarm again.
The Vacation button can be used to activate/deactivate Vacation mode.
If you are going on vacation or a business trip, or if you do not intend
to use the refrigerator for an extended time, use the Vacation feature.
Press and hold Vacation for 3 seconds to turn off the fridge operation
with the Vacation indicator (
NOTE
It is strongly recommended to empty the fridge compartment and
make sure the door is closed.
When connecting the refrigerator to SmartThings App or Samsung
smart devices such as Samsung Smart TVs, follow the app's or device's
onscreen instructions and press and hold Door Alarm for 5 seconds.
The temperature panel displays "on" for 5 seconds before proceeding
with the authentication procedure. Note that the Vacation function will
be not affected by this authentication.
) on.
2018-06-08 11:53:17