Samsung RS6N Serie Mode D'emploi page 39

Water filter replacement (applicable models only)
CAUTION
• Do not use third-party water filters. Use only Samsung-provided or -approved filters.
• Unapproved filters may leak and damage the refrigerator, causing electric shock.
Samsung holds no responsibility for any damage that may occur from use of third
party water filters.
• The filter indicator turns red as a reminder that lets you know it is time to replace the
water filter.
Untitled-10 39
1. Shut off the main water supply.
2. Connect the water supply line to the
inlet side of the filter to the end.
3. Connect the dispenser line to the outlet
side of the filter.
4. Check if there is any leak. If not, fix the
lines with the clips.
5. Put the water filter into place and fix it
with the clips.
6. Press and hold Filter Reset for
3 seconds to reset the filter lifecycle.
7. When replacing is complete, flush 10
litres of water (or dispense the water
for 6 - 7 minutes) to remove impurities
from the water line.
CAUTION
When adjusting the length of the water
line tubing, make sure to smooth out the
cut surface at a right angle. This is to
prevent a water leak.
English 39
2018-06-08 11:53:12