Delta MultiChoice T27T Serie Manuel D'utilisation page 6

Installation
4
Valve Trim Installation
Temperature Handle Installation Step A or A1.
Diverter Handle Installation Step B.
A.
1
2
3
Temperature handle Installation
Secure temperature control knob (1) with screw
(2). See next step for securing temperature control
cover (3).
A1.
3
T27T899 & T27T999 Series
Temperature handle Installation
Attach spacer screw (1) to valve stem (2). Slide
temperature control handle (3) into place over spacer
screw (1). Install set screw (4) using an allen wrench,
place set screw cover (5) over set screw and apply
pressure until cover is properly seated.
5
Potential scald or thermal shock injury could result due to cross flow if outlet at the shower is
blocked or restricted (e.g., pause control on showerhead). Be sure to point showerhead away
from you when re-starting flow or install inlet check valves on both supply lines to prevent
possible injury.
104439 Rev. C
1
2
4
5
4
Snap temperature control cover over temperature
control knob by first aligning smaller tab (1) on
cover with receiving slot (2) on temperature knob.
Swing larger tab (3) to engage with snap feature
(4). Note: If dis-assembly is required, reverse
this motion, disengaging larger tab (3) from snap
feature (4) first.
B.
2
1
3
4
Diverter Handle Installation
Slide diverter handle (1) onto diverter cartridge stem
(2), ensure that handle aligns with cartridge stem.
Install set screw (3) using an allen wrench. Place set
screw cover (4) over set screw and apply pressure
until cover is properly seated.
6
1
2
3