Important - Philips HB953 Manuel

ENGLISH
6
Introduction
The sun
C
The sun supplies various types of energy.Visible light enables us to
see, ultraviolet (UV) gives us a tan and infrared (IR) in sunrays
provides the heat in which we like to bask.
The tanning appliance
With this tanning appliance you can suntan comfortably at home.The
tanning lamps emit visible light, heat and ultraviolet, giving you the
impression you are sunbathing in real sunlight.The special UV filter only
passes the radiation that is required to get a tan.
The tanning lamps emit sufficient infrared to provide a comfortable
warmth.
A timer ensures that each session does not last longer than 30 minutes.
Just as with natural sunlight, overexposure must be avoided (see
chapter 'UV, tanning and your health'.

Important

Check if the voltage indicated on the appliance corresponds to the
mains voltage in your home before you connect the appliance.
If the plug has not been inserted properly into the wall socket, it
may become hot. Make sure you insert the plug properly into the
wall socket.
The appliance must be connected to a circuit that is protected
with a 16A standard fuse or an automatic fuse.
Always unplug the appliance after use.
Water and electricity are a dangerous combination! Do not use
this appliance in wet surroundings (e.g. in the bathroom or near a
shower or swimming pool).
If you have just been swimming or have just taken a shower, dry
yourself thoroughly before using the appliance.
Let the appliance cool down after use for approx. 15 minutes
before folding it back into transport position and storing it.
Make sure the vents in the lamp units and in the base remain open
during use.
The appliance has been fitted with an automatic protection against
overheating. If the appliance is insufficiently cooled (e.g. because
the vents are covered), the appliance will switch off automatically.
Once the cause of overheating has been removed and the
appliance has cooled down, the appliance can be switched on again.