Quick Installation - Tripp-Lite BC350 Manuel D'utilisation

Quick Installation

STEP 1: Plug the UPS into a
properly grounded outlet.
After plugging the UPS into a wall outlet,
press and hold the power button next to the
PROTECTED LED to turn on the UPS (See
Basic Operation).
Note: The UPS will not turn on automatically in
the presence of live utility power.
STEP 2: Plug your
equipment into the UPS.
There are two sets of outlets on your UPS.
Outlets marked SURGE ONLY /
provide battery backup power during power
outages. Connect common desktop items
like printers, scanners and other accessories
not requiring battery support to these outlets.
Outlets marked BATTERY BACKUP /
offer UPS battery backup support during
power failures. Connect your vital computer
equipment into these outlets.
Your UPS is designed to support electronic
equipment only. You will overload the UPS
if the total volt-amp (VA) ratings for all
the equipment connected to the BATTERY
BACKUP / outlets exceed the UPS output
capacity. To find your equipment's VA ratings,
look on their nameplates. If the equipment
is listed in amps (A), multiply the number of
amps by 120 to determine VA. For example:
1A × 120 = 120VA. If you suspect you
have overloaded the outlets, remove some
equipment.
If the PROTECTED LED does not illuminate
when the UPS is turned ON, try the following:
1. Make sure the UPS is plugged into a live
AC outlet.
2. Press and hold the power button next
to the PROTECTED LED to turn on the
UPS. A beep should sound when the UPS
starts.
3. If the UPS still does not start, contact
Tripp Lite Tech Support for assistance.
18-11-058-933864.indb 4
do not
4
11/20/2018 8:28:42 AM